Under Import logic type, select Design entry CIS.Ĭlick the 3 dots (…) on the Import directory and select the path of the folder where you saved your netlist, click OK. psm files are saved, click OKĪfter setting up the paths needed, click OK. pad files are saved, click OK.Īdd the path where your folder with the *. Go to Paths> Library>Click the 3 dots (…) on the padpath rowĪdd the path where your folder with the *. **IMPORTANT: I suggest saving it to all in one folder where all your. The netlist window will appear, under PCB Editor tab, under Options, determine the path where you want to save your netlist by clicking the 3 dots(…) under Netlist Files Directory, click OK. dsn file, click the (+) to SCHEMATIC1 folder then click your schematic design, then click Tools> Create netlist. opj), click the (+) button beside your *. Once you have your schematic design finished, go to your project tab(*. To place symbols into your schematic go to your schematic design tab( *.dsn), click Place Part, click Add library, and navigate to your *.olb file. I´d appreciate to receive appropriate hints.To integrate Orcad schematics to Allegro PCB:Ĭreate a new schematic design by clicking File> New> Design or open your current schematic design by clicking File> Open> Design.Īdd symbols into your library by following our import guide here. Hard to believe that it is related to failing libraries, because the schematic relies on the (internal) design cache. For sure, it has been verified that Intertool Communication (cross probing) has been enabled, but it does not work. I cannot get the setup such that I can operate conveniently. After clicking on Sync, most of the errors are like these:ĮRROR(SPMHNI-189): Problems with the name of device 'XTAL_13Y_XTLOSC4_3P2X2P5MM_SM_IC_24MHZ': 'Name is too long.'.ĮRROR(SPMHNI-170): Device 'XTAL_13Y_XTLOSC4_3P2X2P5MM_SM_I' has library errors.When I execute Update Layout, the Preview shows many Components removed and then added.Result: Everywhere no physical part found for (PART). It is then asked to regenerate netlist (via Tools menu).Preview with report then execute by clicking on Sync. cross probing in operation, all of them operated from the PCB main menu: Yet, some other provisions must be carried out in order to get e.g. The layout can be opened by clicking on the layout which has been added now.add the Layout file by right clicking on "Layout" in the file list viewer (Add Layout).The the following preparatory steps seems to be needed: The design file set consists of a ZIP file with artwork data, a schematic (dsn), a board file (brd), two pdfs and a bom file.Īfter opening the schematic in capture, an opj file is created automatically.
0 kommentar(er)
